Trim - Lower - Fascia - Rear - Remove And Replace: Remove
- Remove the rear fascia assembly. See Fascia Assembly - Rear (Remove And Install) .
- Remove the LH and RH rear reflex lamps. See Lamp - Reflex - Rear - LH (Remove and Replace) .
- Remove the top LH and RH bolts that attach the rear diffuser to the rear fascia assembly.
Tip: Use of the following tool(s) is recommended:
- 10 mm deep socket
- Flex head ratchet/flex head torque wrench
- Position the rear fascia assembly upside down on workbench.
- Remove the screws (x2) and release the tabs (x10) that attach the tow hitch cover to the rear fascia assembly, and then remove the cover from the assembly.
Tip: Use of the following tool(s) is recommended:
- Large flathead screwdriver
- Remove the bottom bolts (x6) that attach the rear diffuser to the rear fascia assembly.
Tip: Use of the following tool(s) is recommended:
- 10 mm deep socket
- Flex head ratchet/flex head torque wrench
- Position the rear fascia assembly upright on the workbench.
- Release the tabs (x8) that attach the rear diffuser to the rear fascia assembly, and then remove the diffuser from the assembly.
- Remove the bolts (x2) that attach the rear lower fascia to the rear fascia assembly.
Tip: Use of the following tool(s) is recommended:
- 10 mm deep socket
- Flex head ratchet/flex head torque wrench
- Release the tabs (x23) that attach the rear lower fascia to the rear fascia assembly, and then remove the lower fascia from the assembly.NOTE: Insert a pick behind the lower fascia tab, and the rotate to pry the fascia assembly tab upward.