Window Regulator Recalibrate
Last Modified: 17/03/2023 06:00:16
NOTE:
See Personal Protection
to make sure to wear proper PPE when performing below procedure.
- Get into the driver seat, and then close the door.
- Use the touchscreen to enable Service Mode. See SERVICE MODE ENABLE AND DISABLE
- Unlock the vehicle Gateway: press and hold the brake pedal, and then push and hold the turn signal stalk fully up for approximately 10 seconds.NOTE: The MCU displays GTW UNLOCKING. Once the gateway is unlocked, the MCU will display GTW UNLOCKED as well as a countdown timer that indicates the remaining time in seconds for the gateway to be unlocked (max. 90 minutes).
- On the touchscreen, touch Controls > Service Mode > Closures > Windows > Calibrate Windows > Start. NOTE: During window calibration, all windows will roll up and down until window calibration is complete.CAUTION: Pinch detection is disabled during calibration.
- Exit Service Mode. See SERVICE MODE ENABLE AND DISABLE