Sensor - Parking Distance - Inner - Rear (HW3) - Remove And Replace: Remove

NOTE: This procedure is applicable to sensors S9 and S10.

Courtesy of TESLA, INC.

1. On the vehicle touchscreen, touch Controls > Service > Jack Mode  to activate Jack Mode.
2. Disconnect LV Power. See LV Power (Disconnect And Connect) .
3. Remove the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install) .
4. Disconnect the electrical harness from the parking distance sensor.
   CAUTION: DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.

   Courtesy of TESLA, INC.

5. Release the parking distance sensor from the rear fascia assembly.

   Courtesy of TESLA, INC.