LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model S Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- Model S >> 2nd Row Seat Assemblies and Hardware >> Bracket - Pivot - Outboard - 2nd Row Seat - RH - Remove And Replace >> Remove

Bracket - Pivot - Outboard - 2nd Row Seat - RH - Remove And Replace: Remove

  1. Remove the RH 2nd row seat back. See SEAT BACK - 2ND ROW - RH (REMOVE AND REPLACE) .
  2. Disconnect the 2nd row seat cushion heat pad electrical connector.
    G15082308Courtesy of TESLA, INC.
  3. Release the clip that attaches the RH body harness to the rear seat back pivot mounting bracket.
    G15082309Courtesy of TESLA, INC.
  4. Remove the bolts (x2) that attach the RH 2nd row seat outboard pivot bracket to the vehicle, and then remove the bracket from the vehicle.

    26 N.m (19.2 ft-lbs) 

    NOTE: Slightly pull the side trim to access the rear bolt.

    Tip: Use of the following tool(s) is recommended:

    • 11 mm socket
    G15082310Courtesy of TESLA, INC.
    G15082311Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals