Amplifier - Audio - External - Remove And Replace: Install
- Position the external audio amplifier into the vehicle, and then install the nuts (x2) that attach the amplifier to the vehicle.
4 Nm (2.9 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Install the bolt that attaches the external audio amplifier to the body.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Connect the external audio amplifier connectors (x3).
- Install the RH trunk side trim. See Trim - Side - Trunk - RH (Remove and Replace).
- Install the RH upper C-pillar trim. See eTrim - C-Pillar - Upper - LH (Remove and Replace).
- Install the RH middle C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
- Install the clips (x4) and tab that attach the RH lower C-pillar trim to the RH middle C-pillar trim.
- Install the RH 2nd row seat outer bolster. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
- Install the rear wall rear trunk trim. See Trim - Rear Trunk - Rear Wall (Remove and Replace).
- Install the trunk floor front trim. See Trim - Front - Floor - Trunk (Remove and Replace).
- Install the RH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
- Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
- Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
- Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
- Connect LV power. See LV Power (Disconnect and Connect).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Restore the RH 2nd row seat to the upright position.
- Raise the RH rear window and close the RH rear door.