- Remove the front aero shield panel. See PANEL - AERO SHIELD - FRONT (REMOVE AND REPLACE)
.
- Release the clips (x2) that attach the valance to the stabilizer bar brackets.
 Courtesy of TESLA, INC.
|
- Remove the push clips (x4) that attach the LH and RH sides of the valance to the wheel liners.
NOTE:
Remove the outer clips as necessary to allow for easier access to the nuts behind the wheel liner.
 Courtesy of TESLA, INC.
|
- Remove the nuts (x2) at the LH and RH corners of the valance.
NOTE:
The nuts are accessed from behind the front of the wheel liners.
 Courtesy of TESLA, INC.
|
- Remove the push clips (x10) that attach the valance to the front fascia, and then remove the valance from the vehicle.
NOTE:
Remove clips from the center first and work outward.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|