Door - Front - LH - Remove and Replace: Remove
- Disconnect 12V power. See 12V/LV POWER (DISCONNECT AND CONNECT) .
- Remove the LH front door trim panel. See PANEL - DOOR TRIM - FRONT - LH (REMOVE AND INSTALL) .
- Remove the LH front door inner belt seal. See SEAL - INNER BELT - FRONT DOOR - LH (REMOVE AND REPLACE) .
- Remove the LH front door outer belt seal. See SEAL - OUTER BELT - FRONT DOOR - LH (REMOVE AND REPLACE) .
- Remove the LH front window motor/regulator assembly. See WINDOW MOTOR/REGULATOR ASSEMBLY - FRONT - LH (REMOVE AND REPLACE) .
- Remove the LH door exterior release handle. See HANDLE - EXTERIOR RELEASE - DOOR - FRONT - LH (REMOVE AND REPLACE) .
- Remove the LH front door latch. See LATCH - DOOR - FRONT - LH (REMOVE AND REPLACE) .
- Remove the LH door mirror. See MIRROR - DOOR - LH (REMOVE AND REPLACE) .
- Remove the button plugs from the bottom of the door.
- Remove the LH lower A-pillar trim. See TRIM - A-PILLAR - LOWER - LH (REMOVE AND REPLACE) .
- Disconnect the door wiring harness connectors at the LH body controller module.
- Release the wiring harness clip from the LH body controller module.
- Push the door wiring harness through the A-pillar bulkhead.
- Release all door harness clips.
- Push the wiring harness through the door bulkhead, and then remove the harness from the door.
- Remove the bolt that attaches the door check to the A-pillar.
24 N.m (17.7 ft-lbs)
CAUTION: Unbolting the door check allows the door to swing freely beyond opening limits. - Release the clips that attach the door check seal to the door, and then remove the seal.
- Remove the nuts that attach the door check inside the door, and then remove the door check from the door.
10 N.m (7.4 ft-lbs)
- Loosen the hinge bolts, and then remove the lower bolts for each hinge.
24 N.m (17.7 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- 10 mm ratcheting combination flex head wrench
- Partially unthread the upper bolt for each hinge, and with assistance, lift the door away from the vehicle.