Glove Box (Without Knee Airbags) - Remove and Replace (RHD): Install

Bring the glove box into the vehicle, and then connect the electrical harness to the glove box solenoid connector, the damper connector, and the puddle light connector.
NOTE: 2 of the electrical connectors are accessed from the bottom of the instrument panel.

CAUTION: Route the electrical harness from the puddle lamp forward of the divider at the linkages.

NOTE: LHD shows, RHD similar

Courtesy of TESLA, INC.
Make sure that the glove box damper pin is fully seated, and not to bump the glove box damper when installing the glove box.
Fasten the clips that attach the glove box to the IP carrier.
NOTE: LHD shows, RHD similar

Courtesy of TESLA, INC.
Install the screws that attach the glove box to the IP carrier.
2.3 N.m (1.7 lbs-ft)

NOTE: LHD shows, RHD similar

Courtesy of TESLA, INC.
close the glove box.
Install the main instrument panel decor trim. See the appropriate Service Information .