LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model 3 Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electrical System (2 Of 2) -- Model 3 >> Exterior Lights >> Light - Side Repeater - Front - LH - Remove and Replace >> Install

Light - Side Repeater - Front - LH - Remove and Replace: Install

  1. Connect the electrical harness to the LH front side repeater light connectors (x2).
    G00622816Courtesy of TESLA, INC.
  2. Firmly install the LH front side repeater light into the LH front fender, secure the clips that attach the light to the fender.
    CAUTION: If reinstalling the same side repeater, make sure the mounting tabs and clips are not damaged. If any of the tabs or clips is damaged, replace the repeater.
    NOTE: The number of clips may vary.
    G14744302Courtesy of TESLA, INC.
  3. Remove the protective tape from the LH fender around the LH front side repeater light.
  4. On the touchscreen, tap Vehicle Info > Driver Assist > Cameras > Reset DAS  , and follow the prompt to run the routine.
  5. Exit the Service Mode. See Service Mode .
  6. Raise the LH front window and close the LH front door.
  7. Inform the customer that manual driving is now required to self-calibrate the camera.
    NOTE: Self-calibration can take up to 100 miles (160 km) of manual driving, depending upon the road type and condition. Until self-calibration is complete, the message "Autopilot Features Currently Unavailable: Manual Driving Required While Camera Is Calibrating" is displayed if an attempt is made to engage an Autopilot feature.
scientia non olet · About LEMON Manuals