LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Exterior Fittings -- Model Y >> Spoiler >> Spoiler - Rear - Remove And Install >> Clean Spoiler

Clean Spoiler

  1. Remove all residual tape from the spoiler using a rubber wheel, trim tool, and isopropyl alcohol (IPA) wipes. Make sure that all residue has been removed and that the spoiler is completely dry before continuing.
    WARNING: To avoid personal injury, eye and ear protection must be worn while performing this step.
  2. Clean the bottom of the spoiler with isopropyl alcohol (IPA) wipes, and allow it to dry for one minute before continuing.
  3. Install the adhesive tape onto the spoiler by peeling off the backing of the adhesive tape and aligning the back side of the tape onto the spoiler.
    G14821452Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals