LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Exterior Fittings -- Model Y >> Exterior Trim >> Mud Flap - LH - Remove And Replace >> Install

Mud Flap - LH - Remove And Replace: Install

  1. Clean the installation area with alcohol and allow to fully dry before installation.
  2. Maneuver the new mud flap in place so that the tabs on the mud flap hook onto the backside of the front fender garnish. Make sure that the mud flap is aligned correctly with the holes in the front wheel arch liner and body of the vehicle.
    G14821447Courtesy of TESLA, INC.
  3. Install the opened (plastic rivet pulled out) new push clip into the inboard hole, and then push the plastic rivet in to close the push clip.
    NOTE: Make sure to install the inboard push clip first.
    G14821448Courtesy of TESLA, INC.
  4. Install the opened (plastic rivet pulled out) new push clip into the outboard hole, and then push the plastic rivet in to close the push clip.
    G14821449Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals