LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Exterior Fittings -- Model Y >> Exterior Trim >> Carrier - Rocker Panel - LH (Structural Pack) - Remove And Replace >> Install

Carrier - Rocker Panel - LH (Structural Pack) - Remove And Replace: Install

  1. Maneuver the LH rocker panel carrier around the front wheel arch liner, then the rear wheel arch liner to position it into the vehicle, and then secure the clips (x10) that attach the carrier to the vehicle.
    G14821417Courtesy of TESLA, INC.
    G14821418Courtesy of TESLA, INC.
    G14821419Courtesy of TESLA, INC.
  2. Install the bolts (x3) and clips (x4) that attach the LH rocker panel carrier to the vehicle.

    12 N.m (8.8 lbs-ft) 

    Tip: Use of the following tool(s) is recommended:

    • 10 mm socket
    G14821420Courtesy of TESLA, INC.
    G14821421Courtesy of TESLA, INC.
    G14821422Courtesy of TESLA, INC.
    G14821423Courtesy of TESLA, INC.
  3. With assistance, position the LH rocker panel cover onto the LH rocker panel carrier, and then secure the clips (x11) and tabs (x11) that attach the cover to the carrier.
    NOTE: The tabs go into the cavities on the rocker carrier and cannot be accessed from the outer side of the cover.
    G14821424Courtesy of TESLA, INC.
  4. Install the clips that attach the LH rocker panel cover to the front and rear wheel arch liners.
    NOTE: Front shown; rear similar
    G14821426Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals