LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- Model Y >> Front Seat Covers Pads And Trims >> Foam - Cushion - Driver Seat - Remove And Replace >> Install

Foam - Cushion - Driver Seat - Remove And Replace: Install

  1. Install a new occupancy sensor onto the new seat cushion foam pad.
    NOTE: Remove adhesion protection, and then attach the occupancy sensor between the indication marks on the foam pad.
    G00651267Courtesy of TESLA, INC.
  2. Route the occupancy sensor connector through the foam pad, and then install the plastic casing onto the connector harness.
    G00651268Courtesy of TESLA, INC.
  3. Install the seat cushion heater mat onto the seat cushion foam pad.
  4. InStall the driver seat cushion trim. See Trim - Cushion - Driver Seat - Remove And Replace .
scientia non olet · About LEMON Manuals