LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Electrical System -- Model Y (2 Of 2) >> Wipers And Washers >> Wiper Arm - RH (RHD) - Remove and Replace >> Remove

Wiper Arm - RH (RHD) - Remove and Replace: Remove

  1. Remove the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
  2. Remove the LH wiper arm nut cover.
    G14834057Courtesy of TESLA, INC.
  3. Release the clip that attaches the LH wiper arm hose to the vehicle.
    G14834058Courtesy of TESLA, INC.
  4. Release the LH wiper arm hose from the Y-tube.
    G14834059Courtesy of TESLA, INC.
  5. Remove the nut that attaches the LH wiper arm to the wiper motor assembly.

    Tip: Use of the following tool(s) is recommended:

    • 15 mm socket
    • 3/8 in std ratchet
    • 3/8 in torque wrench (installation only)
    G14834060Courtesy of TESLA, INC.
  6. Place the base of the wiper arm removal tool under the wiper arm and position the set screw so that it is centered and touching the wiper arm stud, and then tighten the set screw until the wiper arm is released.
    CAUTION: Removing the wiper arm without the wiper arm removal tool can result in damage to the wiper arm or wiper motor.
    G14834061Courtesy of TESLA, INC.
  7. Remove the wiper arm and hose assembly from the vehicle.
    G14834062Courtesy of TESLA, INC.
  8. Repeat step 2 through step 7 for the RH wiper arm and hose assembly.