Bumper Beam - Front - Remove And Replace: Remove

Disconnect 12 V power. See 12 V/LV Power (Disconnect and Connect) .
Remove the front fascia. See Fascia - Front (Remove and Install) .
Disconnect the electrical connectors from the LH and RH front bumper crash accelerometer sensors.
CAUTION: Do not disconnect the crash accelerometer unless 12 V power has been disconnected.

Courtesy of TESLA, INC.
Remove the bolts that attach the LH and RH sides of the front bumper beam to the ankle catcher.
Tip: Use of the following tool(s) is recommended:
- 13 mm socket
- 3 in extension
Courtesy of TESLA, INC.
Remove and discard the bolts that attach the LH and RH sides of the front bumper beam to the LH and RH crush cans.
Tip: Use of the following tool(s) is recommended:
- 15 mm socket
- 3 in extension
Courtesy of TESLA, INC.
Use a prybar to release the front bumper beam from the LH and RH crush cans. Remove the front bumper beam from the vehicle.
CAUTION: Do not damage the body when prying the front bumper.

Tip: Slightly tap the front bumper beam with a dead blow hammer to assist with removal of the front bumper.

Courtesy of TESLA, INC.
Remove the bolts that attach the LH and RH front bumper crash accelerometer sensors.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- 4 in extension
Courtesy of TESLA, INC.
Remove the front bumper beam foam from the front bumper beam.

Courtesy of TESLA, INC.