Taillight - LH - Remove And Replace: Remove
- Open the LH rear door.
- Release the portion of the LH rear door seal that overlaps the LH lower c-pillar trim.
- Fold down the LH 2nd row 60 seatback.NOTE: Protect the seat back upholstery if necessary.
- Remove the rear trunk load floor. See TRUNK LOAD FLOOR - REAR (REMOVE AND REPLACE) .
- Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace) .
- Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace) .
- Remove the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace) .
- Remove the LH trunk pocket bracket. See Bracket - Trunk Pocket - LH (Remove and Replace) .
- Remove the LH trunk side trim. See Trim - Side - Trunk - LH (Remove and Replace) .
- Pull up on the LH liftgate bump stop to remove it from the assembly.
- Release the connector lock, and then disconnect the electrical harness from the taillight connector.CAUTION: DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.CAUTION: If the taillight must be replaced because of water ingress, place a shop towel under the taillight connector to prevent damage to other electrical components.
- Remove the nuts that attach the taillight to the vehicle.
Tip: Use of the following tool(s) is recommended:
- 8 mm 12-point deep socket
- 1/4 in std ratchet
- 1/4 in torque wrench (installation only)
- Remove the LH taillight assembly from the vehicle.