LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Electrical System -- Model Y (2 Of 2) >> Wipers And Washers >> Wiper Arm - RH - Remove and Replace >> Install

Wiper Arm - RH - Remove and Replace: Install

  1. Position the RH wiper arm onto the vehicle.
    NOTE: Make sure the RH wiper tip is aligned between the two indicators at the corner of the windshield.
    G14834063Courtesy of TESLA, INC.
  2. Install the nut that attaches the RH wiper arm to the wiper motor assembly.

    25 N.m (18.4 ft-lbs) 

    Tip: Use of the following tool(s) is recommended:

    • 15 mm socket
    • 3/8 in std ratchet
    • 3/8 in torque wrench (installation only)
    G14834064Courtesy of TESLA, INC.
  3. Connect the RH wiper arm hose to the Y-tube, and then install the hose clip.
    G14834065Courtesy of TESLA, INC.
  4. Install the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
scientia non olet · About LEMON Manuals