LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Electrical System -- Model Y (2 Of 2) >> Interior Switches >> Power Socket 12V - Rear Trunk - Remove and Replace >> Remove

Power Socket 12V - Rear Trunk - Remove and Replace: Remove

  1. Open the liftgate.
  2. Open the LH front door.
  3. Disconnect 12 V/LV power. See 12 V/LV POWER (DISCONNECT AND CONNECT) .
  4. Release the clips (x4) that attach the top edge of the LH trunk side trim to the vehicle, and then carefully pull back the top edge of the trim.

    Tip: Use of the following tool(s) is recommended:

    • Plastic trim tool
    G00627588Courtesy of TESLA, INC.
    G00627589Courtesy of TESLA, INC.
  5. Disconnect the rear trunk power socket 12 V connector.
    CAUTION: Avoid pulling the connector wiring. Press and pull to release the connector.
    G00627590Courtesy of TESLA, INC.
    G00627591Courtesy of TESLA, INC.
  6. Release the rear trunk power socket 12V connector from the LH trunk side trim.
    NOTE: Pull the connector upwards until it clears the mounting tab.
    G00627592Courtesy of TESLA, INC.
    G00627593Courtesy of TESLA, INC.
  7. Gently push the rear trunk power socket 12V forward, while simultaneously pulling the upper and lower mount tabs outward to release the power socket 12V from the LH trunk side trim, and then remove the power socket 12V from the vehicle.

    Tip: Use of the following tool(s) is recommended:

    • Pick Miniature Soft Grip, 90 degree tip, 6 in
    G00627594Courtesy of TESLA, INC.
    G00627595Courtesy of TESLA, INC.
    G00627596Courtesy of TESLA, INC.
    G00627597Courtesy of TESLA, INC.
    G00627598Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals