LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Electrical System -- Model Y (2 Of 2) >> Pedestrian Warning Speaker >> Speaker - Pedestrian Warning - Remove And Replace >> Remove

Speaker - Pedestrian Warning - Remove And Replace: Remove

  1. Remove the RH front wheel. See Wheel (Remove and Install) .
  2. Remove the RH front fender garnish. See GARNISH - FENDER - FRONT - LH (REMOVE AND REPLACE) .
  3. Remove the clips (x8) that attach the front portion of the RH front wheel arch liners to the vehicle, and then move the wheel arch liner aside to perform the following steps.
    G14834146Courtesy of TESLA, INC.
  4. Release the clip that attaches the electrical harness to the pedestrian warning speaker assembly.
    G14834147Courtesy of TESLA, INC.
  5. Slide the locking tab away from the connector, and then press down on the locking tab to disconnect the connector from the pedestrian warning speaker assembly.
    G14834148Courtesy of TESLA, INC.
  6. Remove the screws that attach the pedestrian warning speaker assembly to the front fascia, and then remove the speaker from the fascia.

    1.8 N.m (1.3 ft-lbs) 

    Tip: Use of the following tool(s) is recommended:

    • Torx Plus IP25 socket
    • Flex head ratchet/flex head torque wrench
    • 2 in extension
    G14834149Courtesy of TESLA, INC.
    G14834150Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals