Side Repeater Camera - Front - LH (HW4) - Remove and Replace: Remove
WARNING:
Whenever a camera has been moved out of its original position (for example, a camera or windshield replacement), camera calibration data must be cleared using the vehicle touchscreen: Controls > Service > Camera Calibration > Clear Calibration .
- Remove the LH front side repeater light assembly. See Light - Side Repeater - Front - LH - Remove And Replace
- Remove the bolts (x2) that attach the camera to the LH front side repeater light assembly, and then remove the camera.NOTE:
Wiggle the camera to remove it from the assembly.
Tip: Use of the following tool(s) is recommended:
- Torx T10 bit
- Ratchet/torque wrench