Headlight - LH (RHD) - Remove And Replace: Install

Position the LH headlight onto the body, and then insert the alignment stud into the correct position.
CAUTION: Do not damage the headlight during installation.

Courtesy of TESLA, INC.
Install the fasteners that attach the LH headlight to the body.
5.9 N.m (4.4 ft-lbs)

NOTE: The headlight might not be equipped with a lower fastener.

Tip: Use of the following tool(s) is recommended:
- Torx T30 socket
- 1/4 in std flex head ratchet
- 1/4 in flex head torque wrench (installation only)
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Connect the electrical connector for the LH headlight.

Courtesy of TESLA, INC.
Install the front fascia. See FASCIA - FRONT (REMOVE AND INSTALL) .
NOTE:
After initiating the software reinstall, continue the front fascia installation.
Perform a software reinstall concurrently with the rest of the steps in this procedure. See Software Reinstall - Touchscreen .
NOTE:
After connecting the front fascia electrical connections, pause the procedure to initiate a software reinstall.
Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace) .
Install the underhood storage unit access panel. See Access Panel - Underhood Storage Unit - Remove And Replace .
Install the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
Adjust the headlights:
Courtesy of TESLA, INC.