Closeout Panel - Door - Rear - LH - Remove And Install: Remove
- Remove the rear LH door glass. See GLASS - DOOR - LH - REAR (REMOVE AND REPLACE) .
- Remove the LH rear door outer belt seal. See SEAL - OUTER BELT - REAR DOOR - LH (REMOVE AND REPLACE) .
- Release the connector lock, and then disconnect the LH rear window regulator motor connector.
- Remove the manual latch release cable from the window regulator panel.
- Release the connector lock, disconnect the electrical harness from the LH rear door pressure sensor connector, and then remove the pressure sensor from the LH rear window motor/regulator assembly.
- Release the clips that attach the door harness to the closeout panel.
- Remove the bolts that attach the window regulator assembly to the door.
4 N.m (2.9 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 8 mm socket
- 2 in extension
- Remove the plugs that cover the regulator rail fasteners.
- Remove the bolts that attach the closeout panel assembly to the door, and then slide the assembly down and out to remove it from the door.
8 N.m (5.9 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- 6 in extension