Applique (Roof, Rear) - Remove And Replace: Removal

Open the liftgate and both rear doors.
Apply protective tape on the areas surrounding the rear roof applique to prevent damage.
Release the front and rear seals from the rear roof applique.
NOTE: Components have been removed in this graphic to aid clarity.

Courtesy of TESLA, INC.

NOTE: The rear roof applique is secured to the body by sealant, metal clips (x3), and plastic clips (x2).
Starting from one corner of the rear roof applique, use a cutting blade to cut through the sealant until the applique is loose. Carefully lift the applique and remove it from the vehicle.
CAUTION: Do not damage glass or the harnesses near the liftgate.

Tip: It might be easier to remove the applique while the liftgate is closed.
Use the adhesive scraper to remove the excess adhesive from the liftgate.
Use a vacuum to remove any loose remaining material.
Remove the protective tape from the body of the vehicle.
Clean the remaining adhesive on the liftgate with alcohol wipes. Allow the alcohol to dry for at least 1 minute.