- Install Lower Fascia to Rear Fascia.
NOTE:
21x clips, Recommend assistance.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install screws securing lower fascia to rear fascia.
NOTE:
4x screws, 10mm, 3 Nm.
 Courtesy of TESLA, INC.
|
- Install diffuser to rear fascia.
NOTE:
4x push clips, 13x clips, Recommend assistance.
 Courtesy of TESLA, INC.
|
- Install screws securing diffuser to fascia.
NOTE:
2x screws, 10mm, 3 Nm.
 Courtesy of TESLA, INC.
|
- Install rear reflex lamps into new rear fascia applique.
NOTE:
4x clips 2x 10mm metal clip.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Reconnect rear fascia harness connector.
NOTE:
2x connectors, Located on LH rear side, Recommend assistance, Position fascia for install.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install rear fascia onto vehicle.
NOTE:
24x tabs, Recommended assistance, Align mounting 2 top studs.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Remove masking tape from LH rear quarter panel.
Courtesy of TESLA, INC.
|
- Remove masking tape from RH rear quarter panel.
Courtesy of TESLA, INC.
|
- Install screw securing LH rear fascia to quarter panel.
NOTE:
1x screw, T25, 1.5 Nm.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install screw securing RH rear fascia to quarter panel.
NOTE:
1x screw, T25, 1.5 Nm.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install LH rear fender garnish onto rear fascia.
NOTE:
3x clips, 7 tabs.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install RH rear fender garnish onto rear fascia.
NOTE:
3x clips, 7 tabs.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install clip securing LH rear fender garnish and arch liner.
NOTE:
2x push clip.
 Courtesy of TESLA, INC.
|
- Install clip securing RH rear fender garnish and arch liner.
NOTE:
2x push clip.
 Courtesy of TESLA, INC.
|
- Install bolt securing LH top of fascia to bracket.
NOTE:
1x bolts, 10mm, 4 Nm.
 Courtesy of TESLA, INC.
|
- Install bolt securing RH top of fascia to bracket.
NOTE:
1x bolts, 10mm, 4 Nm.
 Courtesy of TESLA, INC.
|
- Clean LH liftgate body trough trim surface.
NOTE:
Use IPA wipes to clean body surface where trough trim is fasten with double sided strip, Allow 1 minute for dry time.
 Courtesy of TESLA, INC.
|
- Clean RH liftgate body trough trim surface.
NOTE:
Use IPA wipes to clean body surface where trough trim is fasten with double sided strip, Allow 1 minute for dry time.
 Courtesy of TESLA, INC.
|
- Clean LH liftgate trough trim surface.
NOTE:
Use IPA wipes to clean trough trim where double sided tape is attached to, Allow 1 minute for dry time, Apply 3M tape primer to tape surface.
 Courtesy of TESLA, INC.
|
- Clean RH liftgate trough trim surface.
NOTE:
Use IPA wipes to clean trough trim where double sided tape is attached to, Allow 1 minute for dry time, Apply 3M tape primer to tape surface.
 Courtesy of TESLA, INC.
|
- Install double sided tape onto LH trough trim.
NOTE:
4x double sided tape strip.
 Courtesy of TESLA, INC.
|
- Install double sided tape onto RH trough trim.
NOTE:
4x double sided tape strip.
 Courtesy of TESLA, INC.
|
- Install LH liftgate trough trim into place.
NOTE:
1x clip, 4x double sided tape strip, Remove tape backing before installation, Partially lift the main seal for better access.
 Courtesy of TESLA, INC.
|
- Install RH liftgate trough trim into place.
NOTE:
1x clip, 4x double sided tape strip, Remove tape backing before installation, Partially lift the main seal for better access.
 Courtesy of TESLA, INC.
|
- Install LH liftgate stop from vehicle.
NOTE:
1x bump stop.
 Courtesy of TESLA, INC.
|
- Install RH liftgate stop from vehicle.
NOTE:
1x bump stop.
 Courtesy of TESLA, INC.
|
- Close liftgate.
 Courtesy of TESLA, INC.
|
- Raise vehicle fully and lower onto locks.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install bolts securing mid aero shield to rear fascia.
NOTE:
11x bolts, 10mm, 4 Nm, 2x bolt, T30, 4.5 Nm.
 Courtesy of TESLA, INC.
|
- Lower vehicle until tires are touching the ground.
NOTE:
Raise lift off locks, then hold lock release lever to keep locks free while vehicle is lowered.
Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
Courtesy of TESLA, INC.
|
- Remove vehicle from lift.
NOTE:
Lower rack arms fully and move them from under vehicle, Remove air suspension from "Jack Mode" Controls => Service => Jack Mode.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Raise LH front window.
 Courtesy of TESLA, INC.
|
- Close LH front door.
 Courtesy of TESLA, INC.
|