Harness - Damper - Air Suspension - Front - LH - Remove and Replace

Last modified: 13/04/2023 13:48:17

NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.

NOTE: See to make sure wearing proper PPE when performing the below procedure.

WARNING: This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Open LH front door

Courtesy of TESLA, INC.
Lower LH front window

Courtesy of TESLA, INC.
Place air suspension into "Jack Mode"
NOTE: Using MCU touchscreen > Controls > Suspension > Jack Mode

Courtesy of TESLA, INC.
Remove LH front lug nut covers
NOTE: 5x lug nut covers

Courtesy of TESLA, INC.
Loosen LH front lug nuts
NOTE: 5x nuts, 21mm, 175 Nm

Courtesy of TESLA, INC.
Jack up LH front of vehicle
NOTE: Position jack stand adapter onto jack and position on vehicle lift pad so that pin is located in center hole of vehicle lift pad, Jack up and position jack stand under vehicle, Lower jack so jack stand adapter is centered on jack stand

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Remove LH front wheel
NOTE: 5x nuts, 21mm, 175 Nm

Courtesy of TESLA, INC.
Remove clips securing LH front wheelhouse liner to body
NOTE: 14x clips

Courtesy of TESLA, INC.
Remove nuts securing LH front wheelhouse liner
NOTE: 2x nuts, 10mm, 6 Nm

Courtesy of TESLA, INC.
Remove LH front wheelhouse liner from vehicle

Courtesy of TESLA, INC.
Disconnect LH front adaptive air spring module harness connector
NOTE: 1x connector

Courtesy of TESLA, INC.
Disconnect LH front adaptive air spring module connectors
NOTE: 2x connectors

Courtesy of TESLA, INC.
Remove LH front adaptive air spring module harness from brackets
NOTE: 2x grommets

Courtesy of TESLA, INC.
Connect LH front adaptive air spring module connectors
NOTE: 2x connectors

Courtesy of TESLA, INC.
Connect LH front adaptive air spring module harness connector
NOTE: 1x connector

Courtesy of TESLA, INC.
Install LH front adaptive air spring module harness onto brackets
NOTE: 2x grommets

Courtesy of TESLA, INC.
Install LH front wheelhouse liner on vehicle

Courtesy of TESLA, INC.
Install nuts securing LH front wheelhouse liner
NOTE: 2x nuts, 10mm, 6 Nm

Courtesy of TESLA, INC.
Install clips securing LH front wheelhouse liner to body

Courtesy of TESLA, INC.
Install LH front wheel
NOTE: 5x nuts, 21mm, 175 Nm, Start lug nuts by hand before using power tool

Courtesy of TESLA, INC.
Remove jack stands and lower vehicle
NOTE: Raise jack stand pad up and remove jack stand then lower jack slowly and remove

Courtesy of TESLA, INC.
Torque LH front wheel
NOTE: 5x nuts, 21mm, 175 Nm

Courtesy of TESLA, INC.
Install LH front lug nut covers
NOTE: 5x covers

Courtesy of TESLA, INC.
Remove air suspension from "Jack Mode" and set to "Standard" if equipped
NOTE: Using MCU touchscreen > Controls > Suspension > "Standard". Using MCU touchscreen > Controls > Service > "JACK MODE"

Courtesy of TESLA, INC.
Raise LH front window

Courtesy of TESLA, INC.
Close LH front door

Courtesy of TESLA, INC.