LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model X Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- Model X >> Front Seat Covers, Pads, And Trims >> Foam And Trim - Cushion - Driver's Seat - Remove And Replace >> Installation

Foam And Trim - Cushion - Driver's Seat - Remove And Replace: Installation

  1. Position the new seat cushion foam and trim on the driver's seat assembly, and then tuck the rear portion of the trim into the into the seat assembly.
  2. Check that the seat cushion harnesses are untangled, routed properly, and that the seat cushion foam is on top of the seat assembly bar.
    G15201951Courtesy of TESLA, INC.
  3. Fold the seat cushion trim down over the seat cushion foam.
    NOTE: Make sure to align the seat cushion selvedge with the channel in the driver's seat assembly.
    G15201952Courtesy of TESLA, INC.
  4. Smooth the wrinkles out of the seat cushion trim, and then attach the seat cushion trim perimeter j-hook to the driver's seat j-hook channel.
    NOTE: Start from the rear corner of the seat cushion trim, and then work around the perimeter.
    G15201953Courtesy of TESLA, INC.
    G15201954Courtesy of TESLA, INC.
  5. Connect the seat cushion connectors.
    G15201955Courtesy of TESLA, INC.
  6. Install the j-hooks that attach the rear portion of the seat cushion trim to the seat assembly.
    G15201956Courtesy of TESLA, INC.
  7. Install the clips that attach the RH side of the seat cushion trim to the seat assembly.
    G15201957Courtesy of TESLA, INC.
  8. Install the clip that attaches the LH side of the seat cushion trim to the seat assembly.
    G15201958Courtesy of TESLA, INC.
  9. Install the front seat trim to the driver's seat assembly.
    G15201959Courtesy of TESLA, INC.
  10. Install the clip that attaches the electrical harness to the inner seat trim.
    G15201960Courtesy of TESLA, INC.
  11. Install the inner seat trim to the driver's seat assembly.
    G15201961Courtesy of TESLA, INC.
  12. Lift the rear lower panel and install the screw that attaches the inner seat trim to the driver's seat assembly (torque 2 N.m).
    G15201962Courtesy of TESLA, INC.
  13. Connect the seat switch connector to the outer seat trim.
    G15201963Courtesy of TESLA, INC.
  14. Install the outer seat trim to the driver's seat assembly.
    G15201964Courtesy of TESLA, INC.
  15. Lift the rear lower panel and install the screw that attaches the outer seat trim to the driver's seat assembly (torque 2 N.m).
    G15201965Courtesy of TESLA, INC.
  16. Install the j-hooks that attach the rear toe kick to the underside of the driver's seat assembly.
    G15201966Courtesy of TESLA, INC.
  17. Install the driver's seat assembly. See Seat Assembly - 1st Row - LH (Remove and Install) .
  18. Remove any protective tape or fender cover used.
scientia non olet · About LEMON Manuals