60/40 Seat Switch - 2nd Row - LH - Remove and Replace: Remove & Replace
- Using MCU, open all doors
- Remove outer Escutcheon from the seat back
- Fold down 60 seat
- Release rear toe kick from 60 seat assemblyNOTE: 6x J-hooks, Release lower outer two to expose inner 4 clips
- Release the J-hook securing the seat trim togetherNOTE: 1x J-hook
- Unzip the seat back trimNOTE: 2x zippers
- Flip seat trim over
- Remove the hard plastic seat back from the frameNOTE: 11x clips
- Remove the switch from the escutcheon house by pressing the tabs in to release the switchNOTE: 2x tabs
- Disconnect switchNOTE: 1x connector
- Connect the switchNOTE: 1x connector
- Install switch in to the escutcheon housing
- Install the hard plastic seat back to the frameNOTE: 11x clips
- Flip seat trim over the seat
- Zip up the seat back overNOTE: 2x zippers
- Connect the J-hook on the seat back trimNOTE: 1x J-hook
- Secure toe kick to 60 seat assemblyNOTE: 6x J-hooks, Secure inner 4 clips, then lower outer 2
- Unfold the 60 seat assembly
- Remove outer Escutcheon from the seat back
- Using MCU close all doors