LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model X Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- Model X >> 2nd Row Seat Covers Pads And Trims >> Trim - Back Rest - 2nd Row - LH (Bench Seat) - Remove And Replace >> Removal

Trim - Back Rest - 2nd Row - LH (Bench Seat) - Remove And Replace: Removal

  1. Remove the RH 2nd row bench seat from the vehicle, and then remove the seat cushion. See TRIM - CUSHION - 2ND ROW - LH (BENCH SEAT) (REMOVE AND REPLACE) .
  2. Loosen the bolt that attaches the center seat belt to the frame (torque 45 N.m), and then remove the center seat belt.
    G15202044Courtesy of TESLA, INC.
  3. Remove the back board. See BACK BOARD - SEAT BACK - 2ND ROW - LH (BENCH SEAT) .
  4. Loosen the bolt that attaches the lower stop to the LH rear bench seat (torque 5 N.m), and then remove the lower stop.
    G15202045Courtesy of TESLA, INC.
  5. Disconnect the seat heater electrical connector.
    G15202046Courtesy of TESLA, INC.
  6. Remove the fasteners (x2) that attach the airbag to the seat frame (torque 20 N.m).
    G15202047Courtesy of TESLA, INC.
  7. Reinstall the release handle and return the RH bench seat to an upright position.
    NOTE: Install the release handle without the spring clip.
  8. Push the bottom of the seat back trim forward.
    G15202048Courtesy of TESLA, INC.
  9. Remove the outer seat belt escutcheon.
    G15202049Courtesy of TESLA, INC.
  10. Remove the center seat belt escutcheon.
    G15202050Courtesy of TESLA, INC.
  11. Lift up the top part of the seat back trim, feed the outer and center seat belts through the seat cushion pass through, and then remove the back trim from the seat frame.
    G15202051Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals