LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model X Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- Model X >> 2nd Row Seat Assemblies And Hardware >> Latch Actuator - 2nd Row Seat - LH - Remove And Replace >> Installation

Latch Actuator - 2nd Row Seat - LH - Remove And Replace: Installation

  1. Install the new actuator and fasteners.
  2. Secure the latch cable to the actuator and the bracket.
  3. Connect the latch actuator harness.
  4. Pull the latching cable out of the seat back.
    NOTE: On some vehicles, the latching cable might be secured to the seat back with a cable tie. Cut the cable tie; ensure that a new cable is reinstalled during installation.
    G15201381Courtesy of TESLA, INC.
    G15201382Courtesy of TESLA, INC.
    NOTE: On some vehicles, the sides of the latching cable are secured together with a cable tie. Do not cut this cable tie.
    G15201383Courtesy of TESLA, INC.
  5. Connect a laptop with Toolbox 3 to the vehicle.
  6. Unlock the gateway. See Gateway Unlock .
  7. To disable seat install mode, in Toolbox 3, click the Actions  tab, type "Seat-Install" into the search field, click PROC_BCREAR_X_SEAT-INSTALL-MODE-OFF  , click Run  , and allow the routine to complete.
  8. In Toolbox 3, click the Actions  tab, type "PROC_BCS2L" in the search field, click PROC_BCS2L_R2-L_CALIBRATE-S2L-PITCH  , click Run  , and allow the routine to complete.
  9. In Toolbox 3, click the Actions  tab, type "PROC_BCS2L" in the search field, click PROC_BCS2L_R2-L_CALIBRATE-S2L-TRACK  , click Run  , and allow the routine to complete.
  10. Disconnect Toolbox and remove the laptop from the vehicle.
  11. Secure the latching cable inside the seat back.
    NOTE: If the cable was secured to the seat back with a cable tie, install a new one.
  12. Resecure the backrest cushion.
  13. Reinstall the seat back cover.
scientia non olet · About LEMON Manuals