Closeout Panel - Door - Front - LH - Remove and Install: Remove

Remove the LH front door trim panel. See PANEL - DOOR TRIM - FRONT - LH (REMOVE AND INSTALL) .
Remove the front LH front door speaker. See SPEAKER - FRONT DOOR - LH (REMOVE AND REPLACE) .
Remove the bolts that attach the window motor to the closeout panel.
3 N.m (2.2 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- 8 mm socket
- 2 in extension
Courtesy of TESLA, INC.
Disconnect the electrical wiring harness from the LH front door pressure sensor connector.

Courtesy of TESLA, INC.
Disconnect the electrical wiring harness from the LH door mirror connectors.

Courtesy of TESLA, INC.
Release the clips that attach the electrical wiring harness to the closeout panel.

Courtesy of TESLA, INC.
Remove the bolts that attach the closeout panel to the door.
4 N.m (2.9 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- 8 mm socket
- 2 in extension
Courtesy of TESLA, INC.
Release the clips (3x) that attach the closeout panel to the door and window regulator, and then remove the closeout panel from the vehicle.
NOTE: Closeout panel and window regulator shown, other assemblies hidden for clarity.

Courtesy of TESLA, INC.

NOTE: Pass the electrical wiring harness through the hole in the closeout panel, as the closeout panel is being removed.

Courtesy of TESLA, INC.