LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model 3 Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electrical System (2 Of 2) -- Model 3 >> Interior Switches >> Switch - Steering Wheel - RH - Remove and Replace >> Install

Switch - Steering Wheel - RH - Remove and Replace: Install

  1. Install the RH steering wheel switch into the bright surround, and then install the screws (x3) that attach the switch to the surround.

    0.9 N.m (8 in-lbs) 

    G14744181Courtesy of TESLA, INC.
  2. Install the bright surround into the steering wheel, and then install the screws (x4) that attach the surround to the steering wheel.

    5.4 N.m (4.0 ft-lbs) 

    G14744182Courtesy of TESLA, INC.
  3. Install the electrical harness into the steering wheel, and then connect the electrical harness to the lower connector.
    G14744183Courtesy of TESLA, INC.
  4. Move the horn assembly to the center, and then fasten the clips that attach the horn assembly.
    G14744184Courtesy of TESLA, INC.
  5. Connect the electrical harness to the RH steering wheel switch connector.
    G14744185Courtesy of TESLA, INC.
  6. Connect the electrical harness to the LH steering wheel switch connector.
    G14744186Courtesy of TESLA, INC.
  7. Connect the steering wheel electrical harness to the connector.
    G14744187Courtesy of TESLA, INC.
  8. Install the driver airbag. See AIRBAG - DRIVER (REMOVE AND REPLACE) .
  9. Reinstall the vehicle firmware. See SOFTWARE REINSTALL - TOUCHSCREEN .
  10. Connect a laptop with Toolbox 3 to the vehicle.
  11. In Toolbox, click the Actions  tab, type "VCLEFT" in the search field, click on TEST-SELF_ VCLEFT_X_SWC  , and then select Run  .
  12. Click the Actions  tab, type "VCLEFT" in the search field, click on TEST-RESET_ VCLEFT  , and then select Run  .
  13. Disconnect the laptop from the vehicle.
scientia non olet · About LEMON Manuals