LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2020 >> Model 3 Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Accessories Control Systems >> Electrical System (2 Of 2) -- Model 3 >> Wipers and Washers >> Filler Neck - Reservoir - Windshield Washer (RHD) - Remove and Replace >> Remove

Filler Neck - Reservoir - Windshield Washer (RHD) - Remove and Replace: Remove

  1. Remove the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
  2. Remove the bolt that attaches the filler neck to the underhood storage unit.

    5 N.m (3.7 ft-lbs) 

    G14744451Courtesy of TESLA, INC.
  3. Release the clip that attaches the electrical harness to the filler neck.
    G14744452Courtesy of TESLA, INC.
  4. Pull the filler neck directly away from the windshield washer reservoir to remove it.
scientia non olet · About LEMON Manuals