Lamp - Side Repeater - Front - LH: Removal
- If the vehicle is equipped with air suspension, set the suspension to High or Very High, and then place the vehicle in Jack Mode, see JACK MODE ACTIVATION .
- Press the brake pedal to turn on the drive rails.
- Turn the steering wheel fully to the left.
- Apply protective tape to the fender around the LH front side repeater lamp.
- Release the lowest outer clip from the rear of the LH wheel arch liner.
- Move the rear edge of the wheel arch liner and any NVH padding to access the side repeater light from inside the fender.
- Release the tabs (x2) on the front and bottom-facing edges of the LH front side repeater lamp, and then carefully pry the repeater away from the fender.CAUTION: If reinstalling the same side repeater, take care not to damage the mounting tabs.CAUTION: Care must be taken to avoid damage to paintwork and exterior trim.
- Disconnect the electrical connector from the back side of the LH front side repeater lamp.