LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2019 >> Model 3 Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Body -- Model 3 >> Bumper/Fascia >> Fascia - Front - Remove and Replace >> Install

Fascia - Front - Remove and Replace: Install

Installation procedure is the reverse of removal.

  1. Install the front fascia grille onto the front fascia, and then fasten the clips (x9) that attach the grille to the fascia.
    NOTE: Top Clips Shown Below.
    G14738825Courtesy of TESLA, INC.
    NOTE: Bottom Clips Shown Below.
    G14738826Courtesy of TESLA, INC.
  2. Install the screws that attach the front fascia grille to the front fascia.

    1.8 N.m (1.3 ft-lbs) 

    G14738827Courtesy of TESLA, INC.
  3. Install the tow hook cover to the front fascia, and then fasten the clips that attach the cover to the fascia.
    G14738828Courtesy of TESLA, INC.
  4. Install the electrical harness to the front fascia, and then fasten the clips that attach the electrical harness to the fascia.
    G14738829Courtesy of TESLA, INC.
  5. Connect the electrical harness to the ambient air temperature sensor connector.
    G14738830Courtesy of TESLA, INC.
  6. Install the parking distance sensors (x6) to the front fascia, and then fasten the clips that attach the sensors to the fascia.
    NOTE: LH Front Parking Assist Sensor Shown.
    G14738831Courtesy of TESLA, INC.
  7. Connect the electrical harness to all of the front parking distance sensors connectors (x6).
    NOTE: LH Front Parking Assist Sensor Shown.
    G14738832Courtesy of TESLA, INC.
  8. Install the front turn signal/fog light to the front fascia, and then fasten the tabs (x4) that attach the light to the fascia.
  9. Install the screws that attach the front turn signal/fog light to the front fascia.

    2.8 N.m (2.1 ft-lbs) 

    G14738833Courtesy of TESLA, INC.
  10. Fasten the clips that attach the electrical harness to the front turn signal/fog light.
    G14738834Courtesy of TESLA, INC.
  11. Connect the electrical harness to the RH front turn signal/fog light connector.
    G14738835Courtesy of TESLA, INC.
  12. Install the front fascia. See FASCIA - FRONT (REMOVE AND INSTALL) .
  13. Install the front license plate bracket. See BRACKET - LICENSE PLATE - FRONT (REMOVE AND REPLACE) .
  14. Perform a radar sensor calibration only if the front radar sensor likely moved outside of its calibration tolerance (due to front end collision, contact while removing the fascia, etc.). See SENSOR - RADAR - FRONT (CALIBRATION) .
    NOTE: If radar sensor calibration is required, add the correction code separately.
scientia non olet · About LEMON Manuals