Bracket - License Plate - Front - Remove and Replace: Install
- Remove the backing from the long horizontal tape strip on the new front license plate bracket.
- Fold the backing of the vertical tape strips out at a 90 degree angle.
- Hold the license plate bracket horizontally and align the locator tab at the bottom lip of the bracket with the center rib of the fascia grille.
- Rotate the license plate bracket vertically and press the top edge against the front fascia.
- Pull the tape strips out from the sides of license plate bracket.
- Press the bracket against the front fascia to wet out the adhesive tape.
Tip: Use a seam roller to wet out the adhesive tape.
- Install the license plate onto the front license plate bracket, and install the screws that attach the plate to the bracket.
3 N.m (2.2 ft-lbs)