LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2018 >> Model 3 Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Electrical System (2 Of 2) -- Model 3 >> Exterior Lights >> Taillight - LH - Remove and Install >> Install

Taillight - LH - Remove and Install: Install

  1. If the same taillight is to be reinstalled, replace the gaskets from around each taillight mounting bolt (x2) and the taillight electrical connector (x1).
  2. Install new grommets (x2) into the body.
    G14744322Courtesy of TESLA, INC.
  3. Position the LH taillight studs into the grommets, and then install the taillight onto the body.
    NOTE: Reseat the trunk seal over the LH taillight.
    G14744323Courtesy of TESLA, INC.
  4. Install the nuts (x2) that attach the taillight to the vehicle.

    3.2 N.m (2.4 ft-lbs) 

    Tip: Use of the following tool(s) is recommended:

    • 8 mm 12-point deep socket
    • 1/4 in std ratchet
    • 1/4 in torque wrench (installation only)
    G14744324Courtesy of TESLA, INC.
  5. Connect the electrical harness to the taillight connector.
    CAUTION: If the connector has a red locking tab: Push the red locking tab into the connector to engage the connector lock.
    G14744325Courtesy of TESLA, INC.
  6. Tuck the trunk trim carpet back into position.
  7. Install the LH bump stop using the bump stop removal tool.
    G14744326Courtesy of TESLA, INC.
  8. Close the trunk.
scientia non olet · About LEMON Manuals