Motor - Seat Track - Front Passenger Seat - Remove and Replace: Remove
- Open all doors and lower all windows.
- Remove the RH instrument panel end cap. See End Cap - Instrument Panel - LH - Remove And Replace .
- Remove the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH - Remove And Replace .
- Release the bottom half of the RH front door seal.
- Remove the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH - Remove and Replace .
- Use a clip prytool to release the RH front seat harness from the sill trim clips (x3).
- Pull the RH front seat harness from under the RH front cabin carpet.
- Move the RH front seat forward, and then remove and discard the RH front seat rear fasteners (x2).
Tip: Use of the following tool(s) is recommended:
- Torx Plus T45 socket
- Cordless Ratchet/Impact Driver
- Flex head ratchet/flex head torque wrench
- Raise the RH front seat cushion to maximum height for access to the HV battery bolts at the RH front footwell and below the RH front seat.
- Move the RH front seat backward, and then remove and discard the RH front seat front fasteners (x2).
Tip: Use of the following tool(s) is recommended:
- Torx Plus T45 socket
- Cordless Ratchet/Impact Driver
- Flex head ratchet/flex head torque wrench
- Tilt the seat backward to gain access to the underside of the LH front seat.NOTE: Take care when moving the seat. Ensure the carpet is not damaged.
- Remove and discard the bolt that attaches the lift motor assembly to the rear RH link.
Tip: Use of the following tool(s) is recommended:
- Torx Bit T45 Stubby
- Ratchet/torque wrench
- 3 in extension
- Flex head ratchet/flex head torque wrench
- With assistance, remove the bolts (x2) that attach the RH side track assembly to the RH front seat cushion assembly.
Tip: Use of the following tool(s) is recommended:
- Torx T50 Bit Stubby
- 3 in extension
- Flex head ratchet/flex head torque wrench
- Cordless Ratchet/Impact Driver
- Disconnect the front passenger seat track motor electrical connector.
- Use a clip prytool to remove the harness clips (x2) from the RH front seat track motor.
- Release the front passenger seat outer track from the track bridge assembly.NOTE: Pry up on the bridge tack motor tab, and then slide the outer track away to release it.
- Release the RH front seat track bridge assembly from the inner seat track.NOTE: Pry up on the bridge tack motor tab, and then slide the seat track bridge assembly away to release it.