LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2018 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Instrument Panel -- Model 3 >> Instrument Panel >> Cover - Airbag - Knee - Driver - Remove and Replace >> Install

Cover - Airbag - Knee - Driver - Remove and Replace: Install

  1. Install the driver knee airbag into the cover.
    NOTE: Push the tabs into the cover from the side facing the bulkhead, and then push down the remaining tabs into the cover until fully seated.
  2. Pivot the airbag into the cover until the 5 tabs at the rear of the airbag lock into place
  3. Install the driver knee airbag assembly. See AIRBAG - KNEE - DRIVER (REMOVE AND INSTALL) .
scientia non olet · About LEMON Manuals