LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Exterior Fittings -- Model 3 >> Spoiler >> Spoiler - Rear - Remove and Replace >> Install

Spoiler - Rear - Remove and Replace: Install

  1. Clean the spoiler installation surface with isopropyl alcohol (IPA) wipes, and allow it to dry before continuing.
    NOTE: Clean any moisture or contaminates that might be present from rain or vehicle washing, otherwise this might result in poor adhesion of the rear spoiler.
    NOTE: If the trunk surface requires any paint correction, request assistance from the body shop or shop detailer before the installation of the rear spoiler.
    NOTE: It is recommended to perform this procedure indoors. Acceptable ambient and part temperature for installation is 15-43 degrees Celsius (60-110 degrees Fahrenheit) for proper adhesion.
  2. Without removing the adhesive backing on the new rear spoiler, align the spoiler using the masking tape applied during removal.
    G00622410Courtesy of TESLA, INC.
    G00622491Courtesy of TESLA, INC.
  3. Apply masking tape to the center of the rear spoiler and trunk, and then use a marker to draw centering lines on the masking tape.
    NOTE: The centering lines should be approximately 25 mm apart.
    G00622492Courtesy of TESLA, INC.
  4. Verify the rear spoiler fitment on the trunk lid.
    NOTE: Each rear spoiler might have a slight different contour. Make sure the rear spoiler is centered on the trunk lid and its corners are laying flat.
  5. Use a plastic trim tool to cut the masking tape to allow removal of the rear spoiler.
    CAUTION: Do not damage the surfaces of the trunk lid or rear spoiler while using a plastic razor blade.
    G00622493Courtesy of TESLA, INC.
  6. Remove the rear spoiler from the trunk lid, and then remove the adhesive backing from the rear spoiler.
  7. Align the two marks on the masking tape on the rear spoiler with the two marks on the masking tape on the trunk lid. Hold the corners of the rear spoiler away from the trunk lid to install the center section of the rear spoiler first.
  8. Secure each end of the rear spoiler to the trunk lid.
  9. Perform the wet out of the adhesive: Starting at the center, firmly push downward and in towards the front of the vehicle, and then continue outwards towards both ends of the spoiler.
  10. Remove the masking tape from the vehicle, and then clean the work area.
    NOTE: Make sure that the rear spoiler corners are laid flat to the trunk lid and symmetrical.
scientia non olet · About LEMON Manuals