LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Exterior Fittings -- Model 3 >> Exterior Trim >> Brightwork - Upper - LH - Remove and Replace >> Remove

Brightwork - Upper - LH - Remove and Replace: Remove

  1. Open the LH doors.
  2. Pull down to release the front and rear primary body seals from the LH upper brightwork.
    NOTE: It is not necessary to release the seals from the top of the B-pillar applique.
    G14739881Courtesy of TESLA, INC.
  3. Remove the push rivet and the screws (x10) that attach the LH upper brightwork to the body, and then carefully remove the brightwork from the vehicle.
    NOTE: Work from the front to the rear.
    CAUTION: Use an assistant to help remove the brightwork from the rear quarter glass, so as to minimize damage to the paint and trim.

    Tip: Use of the following tool(s) is recommended:

    • Torx T20 socket
    • 1/4 in std ratchet
    • 1/4 in torque wrench (installation only)
    • 2 in extension
    G14739882Courtesy of TESLA, INC.
    G14739883Courtesy of TESLA, INC.
  4. Remove and discard the grommets (x10) from the body.
    G14739884Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals