LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Exterior Fittings -- Model 3 >> Exterior Trim >> Brightwork - Upper - LH - Remove and Replace >> Install

Brightwork - Upper - LH - Remove and Replace: Install

  1. Wipe where the grommets will install with an IPA wipe.
  2. Install new grommets (x10) into the body where the LH upper brightwork will install.
    G14739885Courtesy of TESLA, INC.
  3. Press the seals into the body at the B-pillar corners.
  4. With assistance, carefully install the LH upper brightwork into the rear quarter glass.
  5. Install the LH upper brightwork to the body, and then install the screws (x10) and push rivet that attach the brightwork to the body.

    1 N.m (.7 ft-lbs) 

    Tip: Use of the following tool(s) is recommended:

    • Torx T20 socket
    • 1/4 in std ratchet
    • 1/4 in torque wrench (installation only)
    • 2 in extension
    NOTE: Work from the rear to the front.
    G14739886Courtesy of TESLA, INC.
  6. Press up to fasten the rear and front primary body seals onto the LH upper brightwork.
    NOTE: Work from the rear corner of each seal forward, and make sure that the seal fully engages the brightwork. When installed correctly, the seal edge is not visible.
    G14739887Courtesy of TESLA, INC.
  7. Work each seal around the opening so as to evenly distribute it.
    NOTE: Make sure to push the seal into each corner.
  8. Close the LH doors.
scientia non olet · About LEMON Manuals