LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Exterior Fittings -- Model 3 >> Badges and Films >> Tesla Badge - Rear - Remove and Replace >> Install

Tesla Badge - Rear - Remove and Replace: Install

  1. Open the trunk lid partially to accommodate the rear badge fixture.
  2. Install the rear badge fixture over the rear-view camera and onto the trunk lid, and then attach the fixture in place with tape.
  3. Peel the adhesive backing from the trunk badge, align the badge protective film to the locating posts of the fixture, and then press the badge to the trunk.
  4. Remove the protective film from the badge, and then remove the fixture from the trunk lid.
  5. Replace the protective film over the badge, use a pressure roller to wet-out the badge, and then remove the protective film.
  6. Use an IPA wipe to clean the badge and any remaining debris.
    NOTE: Make sure that all edges of the badge are securely affixed to the trunk lid surface.
  7. Close the trunk lid.
scientia non olet · About LEMON Manuals