LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Doors, Windows And Latches -- Model 3 >> Seals Body Closures >> Seal - Trunk - Remove and Replace >> Install

Seal - Trunk - Remove and Replace: Install

  1. Align the line on the trunk seal to the striker.
    G14739730Courtesy of TESLA, INC.
  2. Install the trunk seal to the perimeter of the trunk.

    Tip: Tap the trunk seal with a rubber hammer and use a plastic trim tool to fully install the trunk seal to the body.

    NOTE: Make sure the bottom of the seal is tucked into the rear fascia.
    G14739731Courtesy of TESLA, INC.
  3. Install the trunk sill trim. See TRIM - SILL - TRUNK (REMOVE AND REPLACE) .
  4. Pull the strings on the trunk seal to seat it flush across the interior.
    G14739732Courtesy of TESLA, INC.
  5. Install the rear trunk floor.
  6. Close the trunk.
scientia non olet · About LEMON Manuals