LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Doors, Windows And Latches -- Model 3 >> Seals Body Closures >> Seal - Secondary - Front Door - LH - Remove and Replace >> Install

Seal - Secondary - Front Door - LH - Remove and Replace: Install

  1. Peel a short section of seal backing and insert the end of the seal into the rear of the inner belt seal.
    NOTE: Make sure that both edges of the seal are under the cutouts for the inner belt seal.
  2. Peel the seal backing and carefully position the edge of the seal to the edge of the marking tape while working around the rear door.
    NOTE: Make sure that the drain holes of the seal are at the bottom of the door.
    NOTE: Do not stretch the seal as it is applied to the door.
    NOTE: Make sure that the open edge of the seal is facing the inside of the door.
  3. Insert the end of the seal into the door glass run seal.
  4. Use a seam roller to attach the seal to the door.
  5. Remove the marking tape from the door, and close the door.
scientia non olet · About LEMON Manuals