LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Doors, Windows And Latches -- Model 3 >> Closure Assist Mechanisms and Hinges >> C-Clips - Strut - Hood - LH - Remove and Replace >> Install

C-Clips - Strut - Hood - LH - Remove and Replace: Install

  1. Use snap ring pliers to install new clips (x2) on the gas strut.
    NOTE: Align the ends of the clip with the grooves on the strut, and then push the clip onto the strut until the clip is fully seated in the notch.
    NOTE: Hood side of strut shown, body side similar.
    G14739406Courtesy of TESLA, INC.
  2. Clean the strut ball studs on the hood mount and hood hinge (x2) with a clean rag.
  3. Position the LH hood gas strut on hood hinge ball stud, and then install the clip that attaches the strut to the hood hinge.
    G14739407Courtesy of TESLA, INC.
  4. Position the LH hood gas strut on hood mount ball stud, and then install the clip that attaches the strut to the hood mount.
    G14739408Courtesy of TESLA, INC.
  5. Remove the hood prop.
  6. Close and open the hood 3 times to verify proper gas strut installation.
scientia non olet · About LEMON Manuals