LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body -- Model 3 >> Bumper/Fascia >> Bracket - Rear - Center - Remove and Replace >> Install

Bracket - Rear - Center - Remove and Replace: Install

  1. Install the bolts that attach the rear center bracket to the body.

    4 N.m (2.9 ft-lbs) 

    NOTE: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
    G14738751Courtesy of TESLA, INC.
  2. Install the clips that attach the rear Bluetooth passive entry antenna electrical harness to the rear center bracket.
    G14738752Courtesy of TESLA, INC.
  3. Install the bolt that attaches the Bluetooth passive entry module to the body.

    3.5 N.m (2.6 ft-lbs) 

    NOTE: Use of the following tool(s) is recommended:
    • T30 socket
    • 2 in extension
    G14738753Courtesy of TESLA, INC.
  4. Connect the electrical wiring harness connector to the rear Bluetooth passive entry module.
    G14738754Courtesy of TESLA, INC.
  5. Install the rear fascia. See FASCIA - REAR (REMOVE AND INSTALL) .
scientia non olet · About LEMON Manuals