LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- Model 3 >> Front Seat Covers Pads and Trims >> Trim - Cushion - Driver Seat - Remove and Replace >> Install

Trim - Cushion - Driver Seat - Remove and Replace: Install

  1. Position the seat cushion trim onto the foam pad, and then reinstall the clips (x18) or the Velcro that attach the seat cushion trim to the foam pad.
    G00637881Courtesy of TESLA, INC.
    G00637882Courtesy of TESLA, INC.
    G00637883Courtesy of TESLA, INC.
    G00637884Courtesy of TESLA, INC.
    G00637885Courtesy of TESLA, INC.
    G00637886Courtesy of TESLA, INC.
    G00637887Courtesy of TESLA, INC.
  2. Attach the strap that attaches the seat cushion trim to the foam pad.
    G00637880Courtesy of TESLA, INC.
  3. Install the seat cushion foam pad to the seat cushion frame, and then fasten the clip strips (x3) that attach the seat cushion to the frame at the outboard and inboard sides, and at the front.
    G00637879Courtesy of TESLA, INC.
    NOTE: Make sure that the seat heater connector and seat occupied sensor assembly pass through the seat suspension or frame.
  4. Fasten the clip that attaches the seat cushion heater connector to the seat underside, and then connect the seat heater mat connector.
    G00637877Courtesy of TESLA, INC.
  5. Install the seat occupied sensor to the seat underside, and then fasten the clip that attaches the sensor to the seat underside.
    G00637876Courtesy of TESLA, INC.
  6. Secure the clip that attaches the seat occupied sensor to the seat assembly, and then connect occupied sensor electrical connector.
    G00637875Courtesy of TESLA, INC.
  7. Fasten the clips (x2) that attach the seat cushion to the seat suspension.
    G00637878Courtesy of TESLA, INC.
  8. Attach the clips that attach the lower section of the seat back trim to the seat suspension.
    G00637874Courtesy of TESLA, INC.
  9. Install the driver seat inboard side shield. See SIDE SHIELD - INBOARD - DRIVER SEAT (REMOVE AND REPLACE) .
  10. Install the driver seat outboard side shield. See SIDE SHIELD - OUTBOARD - DRIVER SEAT (REMOVE AND REPLACE) .
  11. Install the driver seat. See SEAT ASSEMBLY - 1ST ROW (LH) - REMOVE AND REPLACE .
scientia non olet · About LEMON Manuals