LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Fittings -- Model 3 >> License Plate Mountings >> Bracket - License Plate - Rear (EMEA) - Remove and Replace >> Install

Bracket - License Plate - Rear (EMEA) - Remove and Replace: Install

  1. Verify that the thread inserts were not damaged during the removal of the screws.
  2. Clean the trunk lid surface with isopropyl alcohol (IPA) wipes, and then allow the surface to dry before continuing.
  3. Install the screws (x2) that attach the rear license plate bracket to the vehicle.

    1.2 N.m (.9 ft-lbs) 

    G14739838Courtesy of TESLA, INC.
  4. Install the screws (x4) that attach the rear license plate on the rear license plate bracket, if applicable.

    1.2 N.m (.9 ft-lbs) 

scientia non olet · About LEMON Manuals