LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Doors, Windows And Latches -- Model 3 >> Closure Assist Mechanisms and Hinges >> Bracket - Active Hood Strut - LH - Remove and Replace >> Install

Bracket - Active Hood Strut - LH - Remove and Replace: Install

  1. Install the LH active hood strut bracket to the body, and then install the bolt attaches the bracket to the body, to on top of the bracket.

    13 N.m (9.6 ft-lbs) 

    NOTE: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
    • Ratchet/torque wrench
    G14739391Courtesy of TESLA, INC.
  2. Install the bolt that attaches the LH passive hood strut bracket to the body, from inside the wheel arch.

    10 N.m (7.4 ft-lbs) 

    NOTE: Use of the following tool(s) is recommended:
    • 6 mm hex
    • 2 in extension
    • Ratchet/torque wrench
    G14739392Courtesy of TESLA, INC.
  3. Install the strut to the LH active hood strut bracket, and then use a small flat head screwdriver to fasten the clip that attaches the strut to the bracket.
    G14739393Courtesy of TESLA, INC.
  4. Install the actuator. See ACTUATOR - PEDESTRIAN PROTECTION - LH (REMOVE AND REPLACE) .
scientia non olet · About LEMON Manuals