LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Electrical System (2 Of 2) -- Model 3 >> Interior Switches >> Switch - Steering Wheel - LH - Remove and Replace >> Install

Switch - Steering Wheel - LH - Remove and Replace: Install

  1. Install the LH steering wheel switch into the bright surround, and then install the screws (x3) that attach the switch to the surround.

    0.9 N.m (8 in-lbs) 

    G14744165Courtesy of TESLA, INC.
  2. Install the bright surround into the steering wheel, and then install the screws (x4) that attach the surround to the steering wheel.

    5.4 N.m (4.0 ft-lbs) 

    G14744166Courtesy of TESLA, INC.
  3. Install the electrical harness into the steering wheel, and then connect the electrical harness to the lower connector.
    G14744167Courtesy of TESLA, INC.
  4. Move the horn assembly to the center, and then fasten the clips that attach the horn assembly.
    G14744168Courtesy of TESLA, INC.
  5. Connect the electrical harness to the RH steering wheel switch connector.
    G14744169Courtesy of TESLA, INC.
  6. Connect the electrical harness to the LH steering wheel switch connector.
    G14744170Courtesy of TESLA, INC.
  7. Connect the steering wheel electrical harness to the connector.
    G14744171Courtesy of TESLA, INC.
  8. Install the driver airbag. See AIRBAG - DRIVER (REMOVE AND REPLACE) .
  9. Reinstall the vehicle firmware. See SOFTWARE REINSTALL - TOUCHSCREEN .
  10. Connect a laptop with Toolbox 3 to the vehicle.
  11. In Toolbox, click the Actions  tab, type "VCLEFT" in the search field, click on TEST-SELF_ VCLEFT_X_SWC  , and then select Run  .
  12. Click the Actions  tab, type "VCLEFT" in the search field, click on TEST-RESET_ VCLEFT  , and then select Run  .
  13. Disconnect the laptop from the vehicle.
scientia non olet · About LEMON Manuals